This support link is dedicated for remote technical support. Download this link only if a technical support technician advise you to download it. Click the link button below and Run the installation.
We developped the "AutoMobility Sidebar" for you to use as a tool. This Sidebar will give you many different links to help you reach us in the easiest way possible. Once installed, the Sidebar will be located on the right side of your computer screen. (see image below for reference)
For any assistance please call... 1.888.55.START Ext:332.
Autostart Techtool Software upgrade tool
It's now time to Update your Autostart PRG-1000 Tech tool Programmer. To Update your Tech tool, please follow the steps below. On the opening screen of your Tech Tool is a version. The most current version is:
VERSION 2.0 If this version is indicated on the screen, your Tech Tool is Up-to-date.
STEP 1: CLICK HEREto Download the installation manual for the Autostart Tech tool Software. This guide will lead you thru the steps of installing the software and drivers correctly.
STEP 3: Once the PRG-1000 software installed, connect your Weblink updater cable (supplied in your Tech Tool storage case)and Start/Run the PRG-1000 software and follow the Tech Tool Update & Reset Procedure.
iDatalink Passlock Writer Software tool
iDatalink Passlock Writer Software for GM4 compatible vehicles.
- Compatible with ADS-AL-CA hardware - Compatible with ADS-DL hardware
1- Learn the GM4 module to your vehicle following the iDatalink installation manual.
2- Connect the Red lead of your multimeter to the Passlock wire located at the ignition harness of the vehicle. Connect the Black lead of your multimeter to the chassis Ground of the vehicle. Set your multimeter to read Voltage (V).
3- Using the key, Start the vehicle and hold the key in the Start position and take the voltage readings of the passlock wire with the vehicle door open and write the value down. This is the "Passlock Value". Release the key from the start position and write down the value when key is at the ignition position. This is the "Passlock Reference Value".
4- Repeat the same readings with the vehicle door closed. During Start (Passlock Value)and during ignition ON (passlock Reference Value)
(They will be different values)
5- Take your iDatalink module to the computer and connect it to the weblink.
7- Click the "connect" button in the passlock writer software tool.
8- Click "Read" to show the passlock values registered in the module (they should match what you read door open or closed depending if the doors were opened or closed when you learned the module)
9- Use the Passlock Writer software tool to adjust to the best centered value. Make an average of the open door and closed door values you have written down. So make an average value for the "Passlock Value" and another average value for the "Passlock Reference Value". NOTE: (Must write 3 digits after the dot (x.xxx) for each value entries)
10- Click "Write" button in the passlock writer software tool.
11- Bring the module back to the vehicle and DO NOT reset it as it will erase the values you wrote in.
12- Connect the iDatalink module and turn the key to the ON position once.
13- Using this tool will allow you to manually control the values if the BCM doesn't provide the same references values with door opened or closed.
Video instructions to assemble the Encrypt R display
Please follow the short video tutorial on how to assemble your EncryptR display. Also located inside the display shipping box you have received there is already instructions on how to assemble it. These video are available to help you better understand how to assemble it.
Download Autostart Tech Tool Software
Download Splash Screen updater PDF guide 
